beautypg.com

Cli command – Avaya 580 User Manual

Page 455

background image

Document No. 10-300077, Issue 2

14-5

Configuring RIP Routing

CLI Command

To modify RIP interfaces parameters using the CLI enter the following
command from Configure mode:

(configure)#

interface | [type {mbna | ethernet}]

Default Metric

Specify the RIP route metric value. Costing metric used
when advertising the RIP route on this interface.

1 is the default setting. The parameter range is 0-15.

Default Route

Specify the mode for the default route learning on this
interface. Different states include:

Disable - Disables the default route.

Talk Only - Send RIP information to the network.

Listen Only - Receive RIP information from the

network.

Talk/Listen - Both send and receive RIP information

from the network.

Disable is the default setting.

Auth Type

Specify the type of authentication available for use on a
given RIP interface. Authentication types include:

None - No authentication required.

Simple - Uses a clear-text password for validation.

This password is sent unencrypted across the network
to neighboring RIP routers.Available for RIP V2 only.

MD5 - Uses an encrypted Key to validate RIP V2

routing updates from neighboring RIP V2 routers.

None is the default setting

Auth Key

If Auth Type is:

None - leave this field blank, or this field is ignored.

Simple - Enter the clear-text password for validating

RIP packets from neighbor RIP V2 routers.(1-16
characters)

MD5 - Enter the defined Key Chain values under

Routing > IP > RIP > Key Chains.

None is the default setting.

Table 14-2. RIP Interface Web Page Parameters

Parameter

Allows you to...

2 of 2

This manual is related to the following products: