Web agent procedure, Cli command, Creating a vrrp virtual router – Avaya 580 User Manual
Page 402: Creating a vrrp virtual router -74
12-74
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
Web Agent
Procedure
To enable an VRRP on an interface using the Web Agent:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Interfaces.
The IP Interfaces Web page is displayed in the content pane. See
Figure 12-36. IP Interface Web Page
2. Select the interface on which you want VRRP to be enabled.
3. Select Enable from the VRRP field pull-down menu for the interface
you selected.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command
To enable an VRRP on an interface using the CLI, enter the following
command in Configure/Interface mode:
(config-if:
ip vrrp
Creating a VRRP Virtual Router
You can create a VRRP router using either the Web Agent or the CLI.
Web Agent
Procedure
To create a VRRP router from the Web Agent:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click VRRP.
The VRRP Virtual Routers Web page is displayed in the content pane.
See
.