Avaya 580 - Manual (Page 537)

Document No. 10-300077, Issue 2 18-7
Configuring the IPX SAP Protocol
f. Select Enable from the Filter/Suppress pull-down menu.
g. Enter 0 in the Hops field. This ensures that there is no override in
the transmission of data on the network.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
* Note: This filter ensures that all advertising of any known print server
on Interface Remote will be suppressed.
CLI Command To create IPX SAP name filters using the CLI, enter the following
command from Configure mode:
(configure)# ipx sap-name-filter
{outbound | inbound | both} {filter | allow} [hops>]
Creating IPX SAP Network Filters
You can create IPX SAP network filters using wither the Web Agent or the
CLI.
Web Agent
Procedure To create IPX SAP Network filters using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > SAP folders, and
then click Net Filters.
The IPX SAP Net Filters Web page is displayed in the content pane. See
Figure 18-4 .Only the CREATE button is displayed when no IPX SAP
Network Filters are configured.
Figure 18-4. IPX SAP Net Filters Web Page
2. Select CREATE. The Add IPX SAP Net Filter Web page is displayed.
See Figure 18-5 .