Cli command, Viewing rip interface statistics, Web agent procedure – Avaya 580 User Manual
Page 528: Viewing rip interface statistics -8
17-8
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 17
c. Enter 0 in the Start Network field.
d. Enter ffffffff in the End Network field.
e. Select Outbound from the Direction pull-down menu.
f. Select Enable from the Filter/Suppress pull-down menu.
g. Enter 0 in the Ticks and Hops fields.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Filter 2 ensures that the advertising of all networks on the interface
Backbone will be suppressed.
Together, Filter 1 and Filter 2 will act to suppress all network advertising
with the exception of network 10. It is important to note that Filter 2 had the
Precedence field set to 1 and Filter 1 had the Precedence field set to 0. Any
filter with a Precedence of 0 will always override a filter with a precedence
of 1 or higher.
CLI Command
To create and modify IPX RIP filters using the CLI, enter the following
command from Configure mode:
(configure)#
ipx rip-filter
network> {outbound | inbound | both} {filter | allow} [
[
Viewing RIP Interface Statistics
You can view RIP Interface Statistics from either the Web Agent or the CLI.
Web Agent
Procedure
To view RIP Interface Statistics using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > RIP folders, and
then click Interface Statistics.
The RIP Interface Statistics Web page is displayed in the content pane.
2. See
for an explanation of the IPX RIP interface Statistics.
3. Click CLEAR to remove the statistics, or REFRESH to access current
interfaces statistics.