Avaya 580 - Manual (Page 639)

Document No. 10-300077, Issue 2 22-3
Monitoring and Configuring the Forwarding Cache
3. Click:
— APPLY to save your changes
— CANCEL to restore previous settings
— REFRESH to update your system configuration
— CLEAR to reset all configuration parameters to zero.
Table 22-1. Layer-3 Forwarding Cache Configuration Web Page
Parameters for Tree Configuration
Field... For the
protocol... Allows you to...
Hash Mode IP Unicast
(IPU)
IP Multicast
(IPM)
IPX
Configure the table hash lookup mode for
the IP unicast, IP multicast and IPX
protocols. The options are:
• DA-only - Forwarding entries input to the
forwarding table are limited to using
protocol destination address only.
• SA-DA - Forwarding entries input to the
forwarding table are limited to using
destination and source address only.
Aging IP Unicast
IP Multicast
IPX
Configure the IP unicast, IP multicast, or
IPX protocols forwarding table entry aging
status as either Enable (default) or
Disable.
Age Interval IP Unicast
IP Multicast
IPX
The IP unicast, IP multicast, or IPX
protocols forwarding table entry aging
period (in seconds). The valid range is 20-
360 seconds. The default value is 120
seconds.
Maximum
Entries IP Unicast
IP Multicast
IPX
The number of active entries in the IP
unicast, IP multicast, or IPX protocol
forwarding table. This is the maximum
number of active entries per fabric port.
Additional flows are forwarded by the
supervisor module. The default value is
15000.