Avaya 580 - Manual (Page 595)

Document No. 10-300077, Issue 2 20-17
Managing Intelligent Multicasting
CLI Command To create a new static multicast session using the CLI, enter the following
command from Configure mode:
(configure)# set intelligent-multicast static-session
Deleting Static Multicast Sessions
You can delete static multicast sessions using either the Web Agent or the
CLI.
Web Agent
Procedure To delete a static multicast session using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click Static Sessions.
The Static Multicast Sessions Web page is displayed in the content
pane. See
Figure 20-9 . See Table 20-7 for an explanation of the Static
Multicast Sessions Web page parameters.
Figure 20-9. Static Multicast Sessions Web Page
2. Select the checkbox next to the static multicast session that you want to
delete.
MAC Address Enter the MAC address of the new static multicast
session. Specifying the MAC address is not used for an IP
multicast session.
VLAN Enter the VLAN associated with the new multicast
session. Click All to add all VLANs to the multicast
session, or select a specific VLAN from the pull-down
menu.
Table 20-6. Static Multicast Session Configuration Web Page Parameters
Parameter Definition
2 of 2