Avaya 580 - Manual (Page 196)

6-30 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 6
Web Agent
Procedure To configure VTP snooping using the Web Agent:
1. In the navigation pane, expand the Modules & Ports folder, and then
click Configuration. The Module Information Web page is displayed in
the content pane. See
Figure 6-11 .
2. Select the number in the Switch Ports column for the module you want
to configure VTP. The Switch Ports Web page for that module is
displayed. See
Figure 6-13 .
3. Select the port in the Name column on which you want to enable VTP
Snooping throughout the switch. The Switch Port Configuration Web
page is displayed for that port. See
Figure 6-14 .
4. Select either IEEE 802.1Q or Multi-layer from the Trunk Mode pull-
down menu to match the setting of the trunk mode for the switch port at
the other end of the link.
5. Select Enable from the VTP Snooping pull-down menu. This enables
VTP snooping on the switch port.
6. Click APPLY to save your changes, or CANCEL to restore previous
settings.
7. In the navigation pane, expand the L2 Switching > VLANs folders, and
then click VTP Snooping. The VTP Snooping Configuration Web page
is displayed in the content pane. See
Figure 6-16 .
Figure 6-16. VTP Snooping Configuration Web Page
8. See Table 6-4 and configure the VTP Snooping parameters.