Avaya 580 User Manual
Page 388
12-60
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
2. Select an interface and perform one of the following:
—
Click REFRESH to view the latest interface statistics.
—
Click CLEAR All to reset all statistics to zero.
—
Click CLEAR to reset the selected interface.
3. See
for an explanation of the DVMRP Interface Statistics
Web page parameters:
Table 12-20. DVMRP Interface Statistics Parameters
Parameter
Defines the...
DVMRP Interface
IP interface configured with the DVMRP multicast
routing protocol.
Network Address
IP address of the interface configured with the
DVMRP multicast.
Address Mask
IP subnet mask associated with the interface.
State
Current status of the interface. Possible status
indications include:
• UP - The interface is active.
• DOWN - The interface is inactive.
Type
Type of interface configured. Possible values include:
• Broadcast - All traffic is forwarded through the
routers. This is not a tunnel and does not require
encapsulation.
• IPIP Tunnel - All multicast traffic (data and
protocol messages) on this interface is
encapsulated in IP unicast packets with the
protocol set to IPIP (IP in IP).
• Non-Encapsulated Tunnel - All multicast data
traffic on this interface is IPIP encapsulated, but
the protocol messages are simple unicast.
Metric
Interface cost.
IGMP Querier on
Interface
Router is the IGMP querier. The purpose of the IGMP
querier is to periodically poll hosts on your network to
trigger group membership reports.
Next Probe Message
in (sec)
Time (in seconds) remaining until the next probe
message is sent.
Unrecognized Packets
Received
Number of unknown DVMRP messages.
1 of 2