Avaya 580 - Manual (Page 274)

8-52 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 8
Enabling IEDR
* Note: To enable IEDR for ports in a hunt group, you must use a
different command that enables the feature globally for all ports
in all hunt groups on the switch. For information on this
command, see “
Enabling IEDR for Hunt Groups .”
* Note: Do not use ISL Tagging (Trunk Mode: Multilayer) on ports that
have IEDR enabled.
IEDR is disabled by default on gigabit ports. To enable the feature:
1. Enter Global Configuration mode.
The CLI displays the (configure)# prompt.
2. Enter the following command:
set port internal-error-shutdown {/ | | all-ports}
enable
To disable IEDR, enter:
set port internal-error-shutdown {/ | | all-ports}
disable
Enabling IEDR for Hunt Groups
This procedure globally enables IEDR for all ports in all hunt groups on the
switch.
* Note: All ports that have IEDR enabled, whether they are
administratively disabled or enabled, assume the hunt group
IEDR setting if they are placed in a hunt group. If a port has
IEDR enabled before you place it in a hunt group, the show
port internal-error-config command displays the port as
IEDR-enabled regardless of the hunt group IEDR setting.
However, the port in fact assumes the hunt group IEDR setting
(whatever that setting is).
To globally enable IEDR for all ports in hunt groups:
1. Enter Global Configuration mode.
The CLI displays the (configure)# prompt.
2. Enter the following command:
set huntgroup internal-error-shutdown enable