Avaya 580 - Manual (Page 499)

Document No. 10-300077, Issue 2 16-5
Configuring IPX Routing
CLI Commands To enable IPX routing globally using the CLI, enter the following command
from Configure mode:
■
To enable IPX routing globally, (configure)# ipx routing
■
To disable IPX routing globally, (configure)# no ipx routing
Configuring IPX Interfaces
You can create new IPX interfaces and configure up to four interfaces of
different encapsulation types to a VLAN (multinetting). You can configure
an IPX interface using either the Web Agent or the CLI.
Web Agent
Procedure To create a new IPX interface using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > Configuration
folders, and then click Interfaces.
The IPX Interfaces Web page is displayed in the content pane. See
Figure 16-5 .
Table 16-2. IPX Routing Global Configuration Web Page Parameters
Parameter Allows you to...
IPX Routing Select Disable to prevent IPX from routing globally. The
default value is Enable.
Use Default
Route Select Enable if you know the default route. The default
value is Disable.
RIP Select Disable to prevent IPX RIP from routing globally.
This affects all IPX interfaces set up to use the IPX RIP
routing protocol. The default value is Enable.
SAP Select Disable to prevent IPX SAP from routing globally.
This affects all IPX interfaces set up to use the IPX SAP
routing protocol. The default value is Enable.
Maximum
Number of Routes Enter the maximum number of routes that can be added to
the routing table. The switch rounds your entry to the
nearest power of 2. For example, if you enter 1000, the
system rounds this number up to 1024 routes. The default
value is 2048.
Maximum
Number of
Services Enter the maximum number of services that can be added.
The switch rounds your entry to the nearest power of 2. For
example, if you enter 1000, the system rounds this number
up to 1024 services. The default value is 2048.