Cli command, Modifying igmp interfaces, Web agent procedure – Avaya 580 User Manual
Page 360: Modifying igmp interfaces -32, Figure 12-15
12-32
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
Figure 12-15. IGMP Global Configuration Web Page
4. Select Enable from the IGMP field pull-down menu to enable IGMP.
5. Select Enable from the MTRACE field pull-down menu to enable
MTRACE processing.
6. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command
To globally enable IGMP using the CLI, enter the following command from
Configure mode:
(configure)#
set router igmp
Modifying IGMP Interfaces
Web Agent
Procedure
To modify IGMP interfaces from the Web Agent:
1. In the navigation pane, expand the Routing > IGMP folders, and then
click Interfaces. The IGMP Interfaces Web page is displayed in the
content pane. See
*Note: You must first enable “multicast protocol”on an interface
before you can configure IGMP. See “
” earlier in this chapter for more information
on how to select a multicast protocol.