Cli commands, Removing ports from hunt groups, Web agent procedure – Avaya 580 User Manual
Page 194: Cli command, Removing ports from hunt groups -28, Figure 6-15
6-28
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 6
Figure 6-15. Hunt Group Members Web Page
CLI Commands
To view details about hunt group members using the CLI, enter the
following command in configuration mode:
(configure)#
show huntgroup
To add ports to a hunt group using the CLI, enter the following command
from Configure mode:
(configure)#
set port huntgroup {
range>} [...,{
Removing Ports from Hunt Groups
You can remove a port from a hunt group by using either the Web Agent or
the CLI.
Web Agent
Procedure
To remove a port from a hunt group by using the Web Agent:
1. Open the Switch Port Configuration Web page for the port that you want
to remove.
2. Click None in the Hunt Group field.
3. Click Apply.
CLI Command
To remove a port from a hunt group, use the following CLI command:
(configure)#
clear port huntgroup