Avaya 580 - Manual (Page 261)

Document No. 10-300077, Issue 2 8-39
Configuring Ports
4. Use the following command to enable known mode on a port or port
range:
set port known-mode enable
*Note: To prevent the flooding of frames that have unknown
destination addresses, enter all ports on the same VLAN
as the port for which you are enabling MAC address lock.
5. Use the following command to enable intrusion traps on a port or port
range:
set port intrusion-trap enable
6. Use the following command to set the intrusion trap timer to other than
the default setting:
set port intrusion-trap-timer timer-value>
Using the All Module Ports Configuration Web Page
The All Ports Configuration Web page allows you to apply the same
parameter settings to all switch ports in a module using a single command.
To set all switch ports in a module using a single command:
1. In the navigation pane, expand the Modules & Ports folder, and then
click Configuration. The Module Information Web page is displayed in
the content pane. See
Figure 8-2 .
2. Select the switch port number listed for that module from the Switch
Ports column. The Switch Ports Web page is displayed.
3. Select All Module Switch Ports Configuration. The Switch Ports
Configuration - All Ports Web page is displayed. See Figure 8-10 .