Avaya 580 - Manual (Page 406)

12-78 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
4. Click CREATE to save your changes, or CANCEL to restore previous
settings.
CLI Command To create a VRRP router from the CLI, enter the following command in
Configure mode:
(config-if:)# ip vrrp address
address>
Displaying VRRP Statistics
You can display VRRP router statistics by using either the Web Agent or the
CLI.
Web Agent
Procedure To display VRRP virtual router statistics using the Web Agent:
1. In the navigation pane, expand the Routing > IP > Display folders, and
then click VRRP Statistics.
The VRRP Virtual Router Statistics Web page is displayed in the
content pane. See
Figure 12-39 .
Address Owner
Override Enable or Disable Address Owner Override using the
drop-down menu. Enabling Address Owner Override
allows the VIP to reply to ICMP requests if the router is
not the IP Address owner of the virtual router’s IP Address
(the VIP and IP Address are different). Address Owner
Override helps to ensure connectivity and availability of
all virtual routers.
Note: This parameter is not defined in the VRRP RFC
2338. The default value is Disable
Preempt Mode Enable or disable Preempt Mode using the drop-down
menu. Preempt Mode will allow a Backup virtual router
with a higher Priority to preempt a Master virtual router
with a lower Priority. Note that the router that owns the IP
Address associated with the virtual router will always
preempt regardless if this is enabled or disabled. To
disable this feature, set this field to False.
The default value is True.
Table 12-31. Add VRRP Virtual Router Web Page Parameters
Parameter Definition
3 of 3