Creating a port redundancy pair, Overview, Web agent procedure – Avaya 580 User Manual
Page 265: Creating a port redundancy pair -43
Document No. 10-300077, Issue 2
8-43
Configuring Ports
This section contains procedures for the following tasks:
■
Creating a Port Redundancy Pair
■
Deleting a Port Redundancy Pair
■
Disabling or Enabling Port Redundancy
Creating a Port Redundancy Pair
Overview
You can use the Web Agent or CLI to create a port redundancy pair. The
switch supports a maximum of 20 pairs.
You must create a unique name for the pair. If the name is not unique to the
pair, it is assumed that the existing pair is being modified
After creating a redundancy pair, enable port redundancy globally for all
configured pairs. See “
Disabling or Enabling Port Redundancy
” for more
information.
* Note: You must globally disable Spanning Tree and Rapid Spanning
Tree before you can create a port redundancy pair.
Web Agent
Procedure
To create a port redundancy pair
1. In the navigation pane, expand the L2 Switching folder, and then click
Port Redundancy. The Port Redundancy Configuration Web page is
displayed in the content pane.
2. Click Create. The Create Port Redundancy Pair Web page is displayed.
Figure 8-11. Create Port Redundancy Pair Web Page