Cli command, Replacing the primary controller, Replacing the primary controller -7 – Avaya 580 User Manual
Page 307: Figure 10-4
Document No. 10-300077, Issue 2
10-7
Configuring Redundancy Options
Figure 10-4. Switch Fabric Status Web Page
CLI Command
To enable the redundant hardware by using the CLI, enter the following
command from Enable/Configure mode:
(configure)#
set fabric configure-redundant-hardware enable
Replacing the Primary Controller
If a Primary controller fails, notification is provided by:
■
An event log message
■
An error message that displays in the Switch controller field.
This manual is related to the following products: