Avaya 580 - Manual (Page 551)

Document No. 10-300077, Issue 2 19-7
Configuring AppleTalk Routing
CLI Commands Use the following CLI commands in interface mode to create an AppleTalk
interface:
■ (config-if:)# appletalk cable-range
■ (config-if:)# appletalk address
■ (config-if:)# appletalk zone
name>
■ (config-if:)# appletalk vlan
id>
Editing AppleTalk Interfaces
You can edit AppleTalk interfaces using either the Web Agent or the CLI.
Web Agent
Procedure To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an AppleTalk
interface before you can edit an interface. See “ Enabling
AppleTalk Global Routing ” and “ Creating an AppleTalk
Routing Interface ” earlier in this chapter.
1. In the navigation pane, expand the Routing > AppleTalk >
Configuration folders, and then click Interfaces.
The AppleTalk Interfaces Web page is displayed in the content pane.
See
Figure 19-4 .
2. If there is no zone to select or if you want to edit the zones available,
complete this step through step x. If not, skip to step x+1. Select Edit
Zone to edit the AppleTalk zone for this interface.
The Edit AppleTalk Zone Web page is displayed. See Figure 19-5 .
Figure 19-5. Edit AppleTalk Zone Web Page