Avaya 580 - Manual (Page 243)

Document No. 10-300077, Issue 2 8-21
Configuring Ports
CLI Command To configure ports on a gigabit module using the CLI, enter the following
command from Configure mode:
(configure)# set port
* Note: When a port on an 80-Series Gigabit Ethernet module is
disabled, the port link light blinks continuously. In versions
earlier than v5.2.10, the link light extinguished when the port
was disabled.
Loopback tests on ports may fail when traffic is present on the
link at startup.
Configuring Physical Ports on Fast Ethernet Ports
You can configure ports on a Fast Ethernet module using either the Web
Agent or CLI commands.
Web Agent
Procedure To configure ports on a Fast Ethernet module using the Web Agent:
1. In the navigation pane, expand the Modules & Ports folder, and then
click Configuration. The Module Information Web page in the content
pane. See
Figure 8-2 .
2. Select the checkbox in the Slot column next to the Fast Ethernet module
to change the Name field, if desired, change the module name then
Click the APPLY button.
3. Select the number in the Ports column for the Fast Ethernet module that
you want to configure. The Physical Port Configuration Web page is
displayed. See
Figure 8-7 .