Avaya 580 - Manual (Page 596)

20-18 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 20
3. Click DELETE to remove the static multicast session.
CLI Command To delete a static multicast session using the CLI, enter the following
command from Configure mode:
(configure)# clear intelligent-multicast static-session
Creating Static Client Ports
You can create and add static client ports using either the Web Agent or the
CLI.
* Note: You can only add static client ports to static sessions on VLANs
that the port is bound to or on sessions created for All VLANs.
Web Agent
Procedure To create a static client port using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click Static Sessions.
The Static Multicast Sessions Web page is displayed in the content
pane. See
Figure 20-9 .
2. Select the number from the Static Client Ports column. The Static
Multicast Sessions Client Ports Web page is displayed. See Figure 20-
10 .
Table 20-7. Static Multicast Sessions Web Page
Parameter Definition
Select Select the static multicast session to be deleted.
VLAN Displays the VLAN on which the static multicast
session exists.
MAC Address Displays the MAC address of the static multicast
session.
IP Address Displays the IP address associated with the static
multicast session, if available.
Static Client Ports Displays the number of static client ports associated
with the static multicast session and opens the Static
Multicast Session Client Ports Web page.