Avaya 580 - Manual (Page 533)

Document No. 10-300077, Issue 2 18-3
Configuring the IPX SAP Protocol
CLI Command To configure the IPX SAP interfaces using the CLI, enter the following
command from Interface mode:
(config-if )# ipx sap
Creating IPX SAP Filters
This section provides the following procedures:
■
Creating IPX SAP Name Filters
■
Creating IPX SAP Network Filters
Aging Interval
Multiplier Enter the length of time that information from received
SAP updates are kept as a multiplier of the Periodic
Update Interval.Default is 3.
Triggered Updates Select one of the following from the pull-down menu:
• Disable – To prevent SAP updates from being
immediately transmitted to the network in
response to changes in the network topology
• Enable – To allow SAP updates to be
immediately transmitted to the network in
response to changes in the network topology
(default).
Get Nearest Server
Reply Select one of the following from the pull-down menu:
• Disable – To prevent the router from responding
to Get Nearest Server requests received on the
interface
• Enable – To allow the router to respond to Get
Nearest Server requests received on the
interface (default).
Get Nearest Server
Reply Delay(msec.) Specify the delay (in msecs) to wait before responding
to a Get Nearest Service request received on the
interface.Default is 0.
Mode Select one of the following from the pull-down menu:
• Talk/Listen - Send and receive advertisements
(default).
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
Table 18-1. IPX SAP Interface Web Page Parameters
Parameter Allows you to...
2 of 2