Avaya 580 - Manual (Page 521)

User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1 17-1
17 Configuring the IPX RIP
Protocol
Overview
The information and procedures provided in this chapter pertain to layer 3
module configuration only. This chapter provides information about the
Internetwork Packet Exchange (IPX) Routing Interface Protocol (RIP) and
procedures for the following tasks:
■
Configuring IPX RIP Interfaces
■ Creating and Modifying IPX RIP Filters
■
Viewing RIP Interface Statistics
For more information about the CLI commands that are mentioned in this
chapter, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.1
Configuring IPX RIP Interfaces
You can configure IPX RIP interfaces using either the Web Agent or the
CLI.
Web Agent
Procedure To configure IPX RIP interfaces using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > RIP folders, and
then click Interfaces.
The IPX RIP Interfaces Web page is displayed in the content pane. See
Figure 17-1 . If no IPX interfaces are configured, then the No
Interfaces are currently configured message is
displayed.