Enabling the lgmp client, Web agent procedure, Cli command – Avaya 580 User Manual
Page 608: Viewing lgmp clients statistics
20-30
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 20
Enabling the LGMP Client
You can enable the LGMP client statistics using either the Web Agent or the
CLI.
Web Agent
Procedure
To enable an LGMP client using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Client.
The LGMP Client Configuration Web page is displayed in the content
pane. See
*Note: You must enable intelligent multicasting on a global basis
to activate LGMP client configuration.
2. Select Enable from the State field pull-down menu, if it is not already
displayed.
3. Select APPLY to complete the operation, or CANCEL to ignore the
operation.
CLI Command
To enable an LGMP client using the CLI, enter the following command
from Configure mode:
(configure)#
set lgmp client enable
Viewing LGMP Clients Statistics
You can view LGMP clients statistics using either the Web Agent or the
CLI.
Web Agent
Procedure
To view LGMP Client statistics using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Client.
The LGMP Client Configuration Web page is displayed in the content
pane. See
2. See
for an explanation of the LGMP Client Configuration
Web page parameters
3. Click CLEAR to clear the statistics, or REFRESH to refresh the
contents of the table.
CLI Command
To view the LGMP client statistics, use the following CLI command:
>
show lgmp client statistics