Avaya 580 - Manual (Page 163)

Document No. 10-300077, Issue 2 5-21
Configuring SNMP
ATM Module
Community String To delete a community string for the ATM-Uplink module, use the
following command:
(configure)# no snmp-server atm-community
[]
Table 5-12 provides an explanation of the command variables.
Setting the Administrative Contact
CLI Command To set the administrative contact for the switch, use the following CLI
command:
(configure)# snmp-server contact
The switch displays the administrative contact when you enter the show
snmp command. For information on this command, see “
Viewing the
SNMP Status .”
Table 5-13 provides an explanation of the command variable.
Table 5-11. no snmp-server community Command
Parameter Definition
The community string that you want to delete.
[] The IP address from which you want to remove
access to the community string.
Table 5-12. no snmp-server community Command
Parameter Definition
The community string that you want to delete.
[] The IP address from which you want to remove
access to the community string.
Table 5-13. snmp contact Command
Parameter Definition
The name of the administrative contact for the switch.
The contact name can range from 1 to 127 characters.