14 configuring rip routing, Overview, Configuring rip on the switch – Avaya 580 User Manual
Page 451: Web agent procedure, Chapter 14 — configuring rip routing -1, Overview -1 configuring rip on the switch -1, Chapter 14, Configuring rip routing, Configuring rip, Routing
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
14-1
14
Configuring RIP Routing
Overview
* Note: To globally enable the Routing Information Protocol (RIP), see
.”
The information and procedures provided in this chapter pertain to 50-series
layer 3, and licensed 80-series module configurations only:
This section describes:
■
■
■
Creating Trusted RIP Neighbors
■
■
■
For more information about the CLI commands that are mentioned in this
chapter, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.1
Configuring RIP on the Switch
You can configure RIP from either the Web Agent or the CLI.
Web Agent
Procedure
To configure the RIP globally on your switch using the Web Agent:
1. In the navigation pane, expand the Routing > IP > RIP folders, and then
click Global Configuration.
The RIP Global Configuration Web page is displayed in the content
pane. See
.