Cli command, Using the event subsystem, Overview – Avaya 580 User Manual
Page 617: Using the event subsystem -3, Overview -3
Document No. 10-300077, Issue 2
21-3
Monitoring the Avaya Multiservice Switch
Figure 21-1. Active Alarm Table Web Page
CLI Command
Use the show alarms CLI command to view the active alarm table. You can
enter this command in User mode.
Using the Event Subsystem
Overview
The Avaya P580 and P882 Multiservice switches have two activity logs:
■
Event Log - stores a large table of events. You can set the size of the
table. Because these events are stored in switch memory, the list is
cleared each time the switch reboots.
■
Shutdown Log - stores the same information as the event Log, but
generally in a smaller table because the table is stored in the
switch’s nonvolatile RAM (NVRAM). This log list is particularly
useful in assessing the cause of a switch failure because the
information is retained even after the switch restarts.