Snmp, Setting the physical location of the switch, Cli command – Avaya 580 User Manual
Page 164: Setting the physical location of the switch -22
5-22
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 5
SNMP
To set the administrative contact for the switch, use the sysContact object,
OID 1.3.6.1.2.1.1.4.
The complete path to this object is:
iso(1).org(3).dod(6).internet(1).mgmt(2).mib-2(1).system(1).
sysContact(4)
Setting the Physical Location of the Switch
CLI Command
To set the physical location of the switch, use the following CLI command:
(configure)#
snmp-server location
The switch displays the physical location of the switch when you enter the
show snmp command. For information on this command, see “
provides an explanation of the command variable.
SNMP
To set the physical location of the switch, use the sysLocation object, OID
1.3.6.1.2.1.1.6.
The complete path to this object is:
iso(1).org(3).dod(6).internet(1).mgmt (2).mib-2(1).system(1).
sysLocation(6)
Table 5-14. snmp location Command
Parameter
Definition
The physical location of the switch. The location can
range from 1 to 127 characters.