Avaya 580 - Manual (Page 696)

25-22 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 25
Displaying the QoS Settings for a Physical Port
CLI Command Use the show port command to display the QoS settings for a physical port.
This command displays the priority of the port, if the port is set to ignore
802.1p tag priority, and if the port is set to use the DSCP for bridged IP
traffic.
The syntax of the command is:
> show port [{ | } [...,{ |
}]]
Setting Up an ACL Rule
CLI Command Use the access list command to set a rule in an access control list. The rule
that you set up will be applied on all of the ports on the switch. For more
information about using ACL rules, see “
Classifying Traffic by Layer 3 or
Layer 4 Characteristics ” earlier in this chapter.
* Note: You must enable the access control list on which you want to set
a rule. Only one access control list can be enabled at a time.
Table 25-13. Keywords, Arguments, and Options
Keyword, Argument or
Option Definition
The slot number of a module. If you specify
, the switch displays the QoS
settings for all ports on the module in the slot
that you specify.
The slot number of a module, and, either a
port number, or a range of port numbers
having the format Px-Py. For example:
• To specify port 1 on the module in slot
3, enter 3/1.
• To specify ports 1 through 5 on the
module in slot 3, enter 3/1-5.
If you specify , the
switch displays the QoS settings for the port
or range of ports on the module in the slot that
you specify.