Avaya 580 - Manual (Page 526)

17-6 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 17
Example #1: Configuring your switch to suppress advertising of
network 10
To configure your switch to suppress the advertising of network 10 on the
IPX interface named Backbone, complete the following steps:
1. In the navigation pane, expand the Routing > IPX > RIP folders, and
then click Filters.
The IPX RIP Filters Web page is displayed in the content pane. See
Figure 17-2 .
2. Select CREATE to create a new filter. The Add IPX RIP Filter Web
page is displayed. See Figure 17-3 .
3. Configure the following parameters on the Add IPX RIP Filter Web
page:
a. Select Backbone from the Interface pull-down menu.
b. Enter 0 in the Precedence field.
c. Enter 10 in the Start Network field.
d. Enter 10 in the End Network field.
e. Open the Direction pull-down menu and select Outbound.
f. Open the Filter/Suppress pull-down menu and select Enable.
g. Enter 0 in the Ticks and Hops fields.
Ticks Specify the time (in ticks) that the packet takes to reach
the network number you specified. A tick is
approximately 1/18th of a second. This entry is used to
override the value in the RIP packet.
If you enter 0, there will be no override in the
transmission of data on the network.The default is o
Hops Specify the number of routers (hops) that the packet
must pass through before reaching the network number
associated with the IPX interface. This entry is used to
override the value in the RIP packet.
If you enter 0, there will be no override in the
transmission of data on the network. The default is 0
Table 17-2. Add IPX RIP Filters Web Page Parameters
Parameter Allows you to...
2 of 2