beautypg.com

H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 73

background image

7-12

Field

Description

S/W Version

Software version of the AP

Boot-Rom version

Boot ROM version of the AP

Description

Description of the AP

Connection Type

AP connection type: “Master” or “Backup”

Peer AC MAC Address

Peer AC MAC address in case of AC backup

Priority Level

AP connection priority

Echo Interval(s)

Interval for sending echo requests, in seconds

Statistics report
Interval(s)

Interval for sending statistics information messages, in seconds

Cir (Kbps)

Committed information rate in kbps

Cbs (Bytes)

Committed burst size in bytes

Jumboframe Threshold

Threshold value of jumbo frames

Transmitted control
packets

Number of transmitted control packets

Received control packets

Number of received control packets

Transmitted data packets

Number of transmitted data packets

Received data packets

Number of received data packets

Configuration Failure
Count

Count of configuration request message failures

Last Failure Reason

Last configuration request failure reason

Last Reboot Reason

Last reboot reason of the AP:

Normal: The AP was powered off.

Crash: The AP crashed, and the information is needed for analysis.

Tunnel Initiated: The reset wlan ap command is executed on the AC (in this
case, the Tunnel Down Reason is displayed as Reset AP).

Tunnel Link Failure: The fit AP rebooted abnormally because an error occurred
when the AP was establishing a connection with the AC.

Latest Join IP Address

IP address of the last AP

Tunnel Down Reason

The CAPWAP tunnel between the AC and the AP is down when one of the
following occurs:

Neighbor Dead Timer Expire: The AC does not receive an Echo request from
the AP within three times the handshake interval.

Response Timer Expire: The AC sends a control packet to the AP but does not
receive any response within the specified waiting time.

Reset AP: The AP is rebooted by the execution of a command on the AC.

AP Config Change: The corresponding configurations are modified on the AC.

No Reason: Other reasons.

AP Mode

Mode supported by the AP. Currently only the split MAC mode is supported.

AP operation mode

Operation mode of AP. Currently Normal and Monitor modes are supported.

Portal Service

Whether the portal service is enabled or not

Device Detection

Whether device detection is enabled or not

Maximum Number of
Radios

Maximum number of radios supported by the AP