H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 573)

48-13
Figure 48-13 Enable CAC
Select Enable from the CAC drop-down list.
Click Apply.
# Enable CAC for AC_VI in the same way described above.
# Select QoS > Wireless QoS from the navigation tree, select the Wireless QoS tab, find the AP to be
configured in the list, and click the corresponding icon in the Operation column to enter the page for
configuring wireless QoS.
Figure 48-14 The page for setting CAC client number
Select the Client Number option, and then input 10.
Click Apply.
Verifying the configuration
If the number of existing clients in the high-priority ACs plus the number of clients requesting access is
smaller than or equal to the user-defined maximum number of users allowed in high-priority ACs), which
is 10 in this example, the request is allowed. Otherwise, the request is rejected.
SVP Service Configuration Example
Network requirements
As shown in Figure 48-15 , the AC is connected to a Layer 2 switch, and the AP is in the same network
as the AC. It is required that the AP assign SVP packets to AC-VO. To guarantee the highest priority for
AC-VO, set the ECWmin and ECWmax to 0 for AC-VO.