beautypg.com

Adding a group member – H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 342

background image

33-6

Item

Description

Source address

Source address of the IACTP protocol

Auth mode

Select the check box before Auth mode, and select the MD5 authentication mode. This
item is optional.

The control message integrity can be verified when the MD5 authentication mode is
selected. The sender (an AC) calculates a digest based on the content of a control
message. On receiving such a message, the receiver (another AC in the roaming group)
will calculate the digest again and compare it against the digest present in the message
to verify the integrity of the packet received. If the digests are the same, the packet is not
tampered.

Auth key

MD5 authentication key

If you select the MD5 authentication mode, you need to input an authentication key.

Roaming group configuration is available only for inter-AC roaming. For the configuration example of

inter-AC roaming, see

Inter-AC Roaming Configuration Example

.

Adding a Group Member

Select Roam > Roam Group from the navigation tree to enter the page for adding a group member, as

shown in

Figure 33-7

:

Figure 33-7 Add a group member

Table 33-2

describes the configuration items for adding a group member.

Table 33-2 Configuration items for adding a group member

Item

Description

IP address

Add the IP address of an AC to a roaming group.

When you configure a roaming group, the roaming group name configured for the ACs in
the same roaming group must be the same.

VLAN

Configure the VLAN to which the roaming group member belongs.

This configuration item is optional. A VLAN is specified to implement redirection of the
traffic of a client from one AC to another. For detailed application, see

Traffic Redirection

Configuration Example

.