H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 25)

4-2
Module Feature WX5002 WX5002V2
LS8M1WC
MA0
WX5004
LSWM1W
CM10
LSWM1W
CM20
Port
mirroring
Remote
port
mirroring
and
cross-boar
d mirroring
not
supported Remote
port
mirroring
and
cross-boar
d mirroring
not
supported
Not
supported
Remote
port
mirroring
and
cross-boar
d mirroring
not
supported
Not
supported Not
supported
SNMP
Configurati
on of IPv6
destination
addresses
is
supported Configurati
on of IPv6
destination
addresses
is
supported Configurati
on of IPv6
destination
addresses
is
supported Configurati
on of IPv6
destination
addresses
is
supported Configurati
on of IPv6
destination
addresses
is
supported Configurati
on of IPv6
destination
addresses
is
supported
Loopback
test
Supported
on GE
interfaces Supported
on GE
interfaces
Internal
loopback
testing
supported
on GE
interfaces
only
Supported
on GE
interfaces
Internal
loopback
testing
supported
on XGE
interfaces
only Internal
loopback
testing
supported
on GE
interfaces
only
IPv6
routing
Supported Supported Supported Supported Supported Supported
Network
Diagnostic
tools IPv6 ping
supported IPv6 ping
supported IPv6 ping
supported IPv6 ping
supported IPv6 ping
supported IPv6 ping
supported
ACL IPv6 Supported Supported Supported Supported Supported Supported
QoS
Line rate Supported Supported Supported Supported Supported Supported
Advanced
AC
backup
Supported Supported Supported Supported Supported
Not
supported
High
availability Stateful
failover Not
supported
Supported
Not
supported
Supported Supported
Not
supported
Feature Matrix for the WX6000 Series
The switch interface module on the WX6103, and the LSQM1WCMB0, LSBM1WCM2A0, and
LSRM1WCM2A1 access controller modules on the WX6000 series adopt the OAP architecture.
Installed on the expansion slots of switches, they work as OAP cards to exchange data, status and
control information with the switches through their internal service interfaces. The XGE interfaces on
the switch interface module on the WX6103, and the LSQM1WCMB0, LSBM1WCM2A0, and
LSWM1WCM10 access controller modules are internal interfaces. Therefore, you are not
recommended to configure services such as QoS rate limiting and 802.1X authentication on them.