Configuration guidelines, Traffic redirection configuration example, Network requirements – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 352: Traffic redirection configuration example -16, Traffic redirection, Configuration example
33-16
Figure 33-21 Client status after intra-AC roaming
Configuration guidelines
Note the following when configuring inter-AC roaming:
The SSIDs and the authentication and encryption modes of two APs should be the same.
A roaming group must be configured on both of the two ACs.
Do not configure ACs in a roaming group to back up each other.
Traffic Redirection Configuration Example
Network requirements
AC 1 and AC 2 are connected through a Layer 2 switch. Both ACs are in the same network. The IP
address of AC 1 is 192.168.1.100 and that of AC 2 is 192.168.1.101.
A client associates to AP 1. Configure an IACTP tunnel between AC 1 and AC 2 to redirect the
traffic of Client to AC 2.
Configure a VLAN for members in a roaming group to implement traffic redirection