H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 378)

34-23
Configure AP 1 through AP 3 on the AC to establish a CAPWAP connection between the AC and each
AP. For the related configuration, see Wireless Service.
2) Configure automatic power adjustment
Select Radio > Calibration from the navigation tree, and then select the Parameters tab to enter the
Parameters tab page, as shown in Figure 34-22 .
Figure 34-22 Configure automatic power adjustment
Select Auto from the Dynamic Power Select drop-down list.
Click Apply.
Configuration verification
You can view the power of each AP on the Operation tab page, which you can enter by selecting
Radio > Calibration from the navigation tree and then selecting the Operation tab.
When AP 4 joins (the adjacency number becomes 3), the maximum number of neighbors reaches
the upper limit (3 by default), and the AC performs power adjustment after the calibration interval.
You can view the detailed information, such as decrease of the Tx power value, on the History Info
tab page, which you can enter by selecting Radio > Calibration from the navigation tree, selecting
the Operation tab, and then selecting History Info.