H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 330)

32-21
For detailed configuration, refer to Wireless Service Configuration Example .
Figure 32-29 Network diagram for normal WLAN mesh configuration
Configuration procedure
1) Configure MAP and MPP
Select AP> AP Setup from the navigation tree, and click New to enter the page for creating an AP, as
shown in Figure 32-30 .
Figure 32-30 AP setup
Set the AP name to map.
Select the AP model WA2220X-AG.
Select the serial ID as manual, and type the AP serial ID.
Click Apply.
Then configure MPP by following the same steps.
2) Configure mesh service
# Create a mesh service.
Select Wireless Service > Mesh Service from the navigation tree, click the Mesh Service tab to enter
the page for creating a mesh service, as shown in Figure 32-31 .
Figure 32-31 Create a mesh service
Set the mesh service name to outdoor.
Click Apply.
# Configure a pre-shared key.