H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 130)

18-10
Table 18-6 Configuration items for creating an SNMP group
Item Description
Group Name Set the SNMP group name.
Security Level
Select the security level for the SNMP group. The available security levels are:
NoAuth/NoPriv: No authentication no privacy.
Auth/NoPriv: Authentication without privacy.
Auth/Priv: Authentication and privacy.
Read View Select the read view of the SNMP group.
Write View
Select the write view of the SNMP group.
If no write view is configured, the NMS cannot perform the write operations to all MIB
objects on the device.
Notify View
Select the notify view of the SNMP group, that is, the view that can send trap messages.
If no notify view is configured, the agent does not send traps to the NMS.
ACL
Associate a basic ACL with the group to restrict the source IP address of SNMP packets,
that is, you can configure to allow or prohibit SNMP packets with a specific source IP
address, so as to restrict the intercommunication between the NMS and the agent.
Return to SNMPv3 configuration task list .
Configuring an SNMP User
Select Device > SNMP from the navigation tree, then click the User tab to enter the page as shown in
Figure 18-13 . Click Add to enter the Add SNMP User page, as shown in Figure 18-14 .
Figure 18-13 SNMP user