H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 588)

49-13
Figure 49-11 Configure connection priority
Table 49-5 describes the configuration items of configuring connection priority.
Table 49-5 Connection priority configuration items
Item Description
AP Connection Priority Set the priority for the AP connection to the AC.
Configuring Load Balancing
Configuration prerequisites
Before configuring load balancing, make sure that:
The target APs are associated with the same AC.
The clients can find the APs.
Configuration task list
Perform the following tasks to configure load balancing:
Task Remarks
Configuring a load balancing mode Required
Configuring AP-based load
balancing
Configuring group-based load
balancing
Required
Use either approach
AP-based load balancing: After you complete Configuring a load
balancing mode , the AC adopts by default.
Group-based load balancing: You are recommended to complete
Configuring a load balancing mode first. A load balancing group
takes effect only when a load balancing mode is configured.