beautypg.com

Configuration verification, Configuration guidelines, Automatic power adjustment configuration example – H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 377: Network requirements, Own in, Figure 34-20

background image

34-22

Figure 34-20 Perform manual channel adjustment

Select the check box of the target radio, and click Channel Optimize.

Configuration verification

You can view the channel status on the Operation tab page, which you can enter by selecting

Radio > Calibration from the navigation tree, and then selecting the Operation tab.

You can view the detailed information, such as the specific reason for channel adjustment on the

History Info tab page, which you can enter by selecting Radio > Calibration from the navigation

tree, selecting the Operation tab, and then selecting History Info.

Configuration guidelines

If you select manual channel adjustment, click Channel Optimize on the Operation tab page every

time you perform manual channel adjustment.

Automatic Power Adjustment Configuration Example

Network requirements

As shown in

Figure 34-21

, AP 1 through AP 3 are connected to the AC. It is required to configure

automatic power adjustment and specify the adjacency factor as 3 on the AC. In this way, when AP 4

joins, the AC performs automatic power adjustment to avoid interference.

Figure 34-21 Network diagram for automatic power adjustment configuration

1) Before configuring automatic power adjustment, complete the following task: