H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 189)

25-3
Table 25-1 Description of the fields of the IPv4 active route table
Field Description
Destination IP Address
Mask
Destination IP address and subnet mask of the IPv4 route
Protocol Protocol that discovered the IPv4 route
Preference
Preference value for the IPv4 route
The smaller the number, the higher the preference.
Next Hop Next hop IP address of the IPv4 route
Interface
Outgoing interface of the IPv4 route. Packets destined for the specified
network segment will be sent out the interface.
Creating an IPv4 Static Route
Select Network > IPv4 Routing from the navigation tree and click the Create tab to enter the IPv4
static route configuration page, as shown in Figure 25-2 .
Figure 25-2 Create an IPv4 static route
Table 25-2 describes the IPv4 static route configuration items:
Table 25-2 IPv4 static route configuration items
Item Description
Destination IP Address Type the destination host or network IP address, in dotted decimal notation.
Mask
Type the mask of the destination IP address.
Select a mask length (number of consecutive 1s in the mask) or a mask in dotted
decimal notation from the drop-down list.
Preference
Set a preference value for the static route. The smaller the number, the higher the
preference.
For example, specifying the same preference for multiple static routes to the same
destination enables load sharing on the routes, while specifying different
preferences enables route backup.
Next Hop Type the next hop IP address, in dotted decimal notation.