beautypg.com

Configuring wireless location – H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 592

background image

49-17

Before switching the work mode, you must download the fat AP software to the AP. Then select Device

> Software Upgrade from the navigation tree to enter the page where you can get the application file

from the local host.

Configuring Wireless Location

Select Advanced > Wireless Location from the navigation tree to enter the page for displaying and

configuring wireless location on an AC, as shown in

Figure 49-15

.

Figure 49-15 Wireless location configuration page

Table 49-10

describes the configuration items of wireless location.

Table 49-10 Wireless location configuration items

Item

Description

Location Function

Enable: Enables the wireless location function globally. The device begins to listen to
packets when wireless location is enabled.

Disable: Disables wireless location globally.

To ensure the location function, complete the configuration on the location server and AC:

On the location server: Configure whether to locate Tags or MUs, Tag message
multicast address, and dilution factor on the location server. These settings will be
notified to the APs through the configuration message. For more information about
location server and configuration parameters, see the location server manuals.

On the AC: Configure the AP mode settings, and enable the wireless location function.

When configurations are correctly made, APs wait for the configuration message sent by
the location server, and after receiving that message, start to receive and report Tag and
MU messages.