H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 520)

45-8
Figure 45-3 The page for configuring an basic IPv4 ACL
Table 45-9 describes the configuration items for creating a rule for a basic IPv4 ACL.
Table 45-9 Configuration items for a basic IPv4 ACL rule
Item Description
ACL
Select the basic IPv4 ACL for which you want to configure rules.
Available ACLs are basic IPv4 ACLs that have been configured.
Rule ID
Select the Rule ID check box and type a number for the rule.
If you do not specify the rule number, the system will assign one automatically.
Action
Select the action to be performed for IPv4 packets matching the rule.
Permit: Allows matched packets to pass.
Deny: Drops matched packets.
Check Fragment
Select this check box to apply the rule to only non-first fragments.
If you do no select this check box, the rule applies to all fragments and
non-fragments.
Check Logging
Select this check box to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the matched packets,
protocol that IP carries, source/destination address, source/destination port number,
and number of matched packets.
Source IP Address
Source Wildcard
Select the Source IP Address check box and type a source IPv4 address and
source wildcard, in dotted decimal notation.
Time Range
Select the time range during which the rule takes effect.
Available time ranges are those that have been configured.