H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 127)

18-7
Figure 18-7 Create an SNMP view (II)
Table 18-4 describes the configuration items for creating an SNMP view. After configuring the
parameters of a rule, click Add to add the rule into the list box at the lower part of the page. After
configuring all rules, click Apply to crate an SNMP view. Note that the view will not be created if you
click Cancel.
Table 18-4 Configuration items for creating an SNMP view
Item Description
View Name Set the SNMP view name.
Rule
Select to exclude or include the objects in the view range determined by the
MIB subtree OID and subtree mask.
MIB Subtree OID
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can
uniquely identify a MIB subtree.
Subtree Mask
Set the subtree mask.
If no subtree mask is specified, the default subtree mask (all Fs) will be used
for mask-OID matching.
Adding rules to an SNMP view
Click the icon corresponding to the specified view on the page as shown in Figure 18-5 , the Add
rule for the view ViewDefault window appears as shown in Figure 18-8 . After configuring the
parameters, click Apply to add the rule for the view. Table 18-4 describes the configuration items for
creating an SNMP view.