H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 192)

25-6
Figure 25-5 Network diagram for IPv4 static route configuration
Configuration outlines
1) On Switch A, configure a default route with Switch B as the next hop.
2) On Switch B, configure one static route with Switch A as the next hop and the other with AC as the
next hop.
3) On AC, configure a default route with Switch B as the next hop.
Configuration procedure
1) Configure the IP addresses of the interfaces (omitted)
2) Configure IPv4 static routes
# Configure a default route with the next hop address 1.1.4.2 on Switch A (omitted).
# Configure two static routes on Switch B: one with destination address 1.1.2.0/24 and next hop
address 1.1.4.1, and the other with destination address 1.1.3.0/24 and next hop address 1.1.5.6
(omitted).
# Configure a default route on AC.
After you log in to the Web interface of AC, select Network > IPv4 Routing from the navigation
tree and then click the Create tab to enter the IPv4 static route configuration page, as shown in
Figure 25-6 .
Figure 25-6 Configure a default route
Type 0.0.0.0 for Destination IP Address.
Select 0 (0.0.0.0) from the Mask drop-down list.
Type 1.1.5.5 for Next Hop.
Click Apply.