H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 545)

46-16
Table 46-10 Items for configuring actions for a traffic behavior
Item Description
Please select a behavior Select an existing behavior in the drop-down list.
Enable/Disable Enable or disable CAR
CIR Set the committed information rate (CIR), the average traffic rate.
CBS
Set the committed burst size (CBS), number of bits that can be sent in
each interval.
Discard
Pass
CAR
Red
Remark
DSCP Pass
Set the action to perform for exceeding packets.
After selecting the Red check box, you can select one of the following
two options:
Discard: Drops the exceeding packet.
Pass: Permits the exceeding packet to pass through.
IP Precedence
Configure the action of marking IP precedence for packets.
Select the IP Precedence check box and then select the IP
precedence value to be marked for packets in the following drop-down
list. Select Not Set to cancel the action of marking IP precedence.
Dot1p
Configure the action of marking 802.1p priority for packets.
Select the Dot1p check box and then select the 802.1p priority value to
be marked for packets in the following drop-down list. Select Not Set
to cancel the action of marking 802.1p priority.
Local Precedence
Configure the action of marking local precedence for packets.
Select the Local Precedence check box and then select the local
precedence value to be marked for packets in the following drop-down
list. Select Not Set to cancel the action of marking local precedence.
Remark
DSCP
Configure the action of marking DSCP precedence for packets.
Select the DSCP check box and then select the DSCP precedence
value to be marked for packets in the following drop-down list. Select
Not Set to cancel the action of marking DSCP precedence.
Max Bandwidth Configure the maximum bandwidth for expedited forwarding (EF).
CBS Configure the CBS for EF.
Percent Configure the percent of available bandwidth for EF.
EF
CBS-Ratio Configure the ratio of CBS to CIR for EF.
Min Bandwidth
Configure the minimum guaranteed bandwidth for assured forwarding
(AF).
AF
Percent Configure the percent of available bandwidth for AF.
Queue
WFQ
Configure WFQ for the default class by inputting the total number of
fair queues, which must be a power of two.
Filter
Configure the packet filtering action.
After selecting the Filter check box, select one item in the following
drop-down list:
Permit: Forwards the packet.
Deny: Drops the packet.
Not Set: Cancels the packet filtering action.
Accounting
Configure the traffic accounting action.
Select the Accounting check box and select Enable or Disable in the
following drop-down list to enable/disable the traffic accounting action.