H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 288)

31-34
Figure 31-42 Display AP
6) Enable 802.11g radio
Select Radio > Radio from the navigation tree, find the AP with the corresponding radio mode and
select the check box before the AP, and then click Enable.
Configuration verification
Select Summary > Client from the navigation tree to enter the page as shown in Figure 31-43 to
view the online clients.
Figure 31-43 View the online clients
For an AC to get the IP address of a client, enable ARP snooping in system view. By default, ARP
snooping is disabled, and IP address 0.0.0.0 is displayed in the IP Address column.
The client can be pinged successfully on the AC.
Configuration guidelines
Note the following when configuring an AP:
Select a correct district code.
Remove the binding between the wireless service and the AP before deleting a wireless service.
Select the AP (AP 1 in the example) with working mode having been switched when enabling the
AP radio, rather than the AP in the auto AP template (ap in the example).
If you enable the radio of the AP in an auto AP template first, radios of all the automatically found
APs are enabled.