Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 574
48-14
Figure 48-15 Network diagram for SVP service configuration
Configuration procedure
1) Configure the wireless service
# Configure the AP, and establish a CAPWAP connection between the AC and the AP.
For related configurations, refer to Wireless Service Configuration. You can strictly follow the steps in
the related configuration example to establish a CAPWAP connection between the AC and the AP.
2) Configure wireless QoS
# Select QoS > Wireless QoS from the navigation tree, and select the Wireless QoS tab to enter the
page shown in
. Make sure that WMM is enabled.
Figure 48-16 Wireless QoS configuration page
# Select QoS > Wireless QoS from the navigation tree, select the Wireless QoS tab, find the AP to be
configured in the list, and click the corresponding
icon in the Operation column to enter the page for
configuring wireless QoS.
Figure 48-17 Configure SVP mapping
Select the SVP Mapping option, and select AC_VO from the following drop-down list.
Click Apply.
# Select the AP to be configured in the list and click the corresponding
icon in the Operation column
to enter the page for configuring wireless QoS. In the Radio EDCA list, select the priority type (AC_VO
is taken for example here) to be modified, and click the corresponding
icon in the Operation column
to enter the page for setting radio EDCA parameters.