H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 162)

22-5
Figure 22-4 Add a static ARP entry
Table 22-1 describes the static ARP entry configuration items.
Table 22-1 Static ARP entry configuration items
Item Description
IP Address Type an IP address for the static ARP entry.
MAC Address Type a MAC address for the static ARP entry.
VLAN
ID
Advanced
Options
Port
Type a VLAN ID and specify a port for the static ARP entry.
The VLAN ID must be the ID of the VLAN that has already been created, and the port
must belong to the VLAN. The corresponding VLAN interface must have been created.
Static ARP Configuration Example
Network Requirements
As shown in Figure 22-5 , an AC is connected to a router via GigabitEthernet 1/0/1, which belongs to
VLAN 100. The IP address of the router is 192.168.1.1/24. The MAC address of the router is
00e0-fc01-0000.
To enhance communication security between the AC and the router, a static ARP entry needs to be
configured on the AC.
Figure 22-5 Network diagram for configuring static ARP entries (on an AC)
Configuration procedure
# Create VLAN 100.