H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 244)

29-4
IPv6 ping operation
Select Diagnostic Tools > Ping from the navigation tree to enter the IPv6 ping configuration page.
Then click Display Advanced Config to display the configurations of the advanced parameters of IPv6
ping operation, as shown in Figure 29-3 .
Figure 29-3 IPv6 ping
After the above configuration, type the IPv6 address or host name of the destination device in the
Destination IP address or host name box, and set the advanced parameters for the IPv6 ping
operation. Then click Start to execute the ping command, and you can see the result in the Summary
box, as shown in Figure 29-4 .
Figure 29-4 IPv6 ping operation results