H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 294)

31-40
Configuration procedure
1) Configure the AP
# Create an AP
Select AP > AP Setup from the navigation tree, and click Create to enter the page for creating an AP,
as shown in Figure 31-54 :
Figure 31-54 Create an AP
Set the AP name to ap.
Select the AP model WA2220X-AG.
Select the serial ID as manual, and type the AP serial ID.
Click Apply.
2) Configure wireless service
# Create a wireless service
Select Wireless Service > Access Service from the navigation tree, and click New to enter the page
for creating a wireless service, as shown in Figure 31-55 :
Figure 31-55 Create a wireless service
Set the service name to mac-auth.
Select the wireless service type clear.
Click Apply.
# Configure wireless service
After you have created a wireless service, you will enter the wireless service configuration page. You
need to perform security setup when configuring MAC authentication, as shown in Figure 31-56 :