Creating a traffic behavior – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 543
46-14
Item
Description
Service VLAN
Define a rule to match service VLAN IDs.
If multiple such rules are configured for a class, the new configuration does not
overwrite the previous one.
You can configure multiple VLAN IDs each time. If the same VLAN ID is
specified multiple times, the system considers them as one. The relationship
between different VLAN IDs is logical OR. After such a configuration. You can
specify VLAN IDs in two ways:
Enter a range of VLAN IDs, such as 10-500. The number of VLAN IDs in
the range is not limited.
Specify a combination of individual VLAN IDs and VLAN ID ranges, such as
3, 5-7, 10. You can specify up to eight VLAN IDs in this way.
VLAN
Customer VLAN
Define a rule to match customer VLAN IDs.
If multiple such rules are configured for a class, the new configuration does not
overwrite the previous one.
You can configure multiple VLAN IDs each time. If the same VLAN ID is
specified multiple times, the system considers them as one. The relationship
between different VLAN IDs is logical OR. You can specify VLAN IDs in two
ways:
Enter a range of VLAN IDs, such as 10-500. The number of VLAN IDs in
the range is not limited.
Specify a combination of individual VLAN IDs and VLAN ID ranges, such as
3, 5-7, 10. You can specify up to eight VLAN IDs in this way.
ACL
ACL IPv4
Define an IPv4 ACL-based rule.
The ACLs available for selection are existing IPv4 ACLs.
QoS policy configuration task list
Creating a Traffic Behavior
Select QoS > Behavior from the navigation tree and click the Create tab to enter the page for creating
a traffic behavior, as shown in
.
Figure 46-10 The page for creating a traffic behavior
describes the configuration items for creating a behavior.